Inficon IC6, Operating Manual

Page: 131 / 342

6 - 3
IP
N 07
4-
50
5-
P1
E
IC6 Operating Manual
6.4 Process Layers 1 - 10 etc.
Layers are shown in groups of 10. Moving the cursor down to one of the layer
groups labeled 1 - 10 etc. in the left display pane, shows the layer parameters.
Use the cursor keys to move among and through the layers. Parameters are
entered with the numeric keypad.
Figure 6-3 Layer definitions
6.4.1 Layer Parameters
6.4.1.1 Layer Parameter Editing
On the Process Layer Detail page the user will be allowed to insert or delete one
or more layers into or from an existing or a new process.
Place the cursor on any parameter in the layer to be copied or deleted. Pressing
F1 Tag Layer will set a tag marker. Tag markers are used to indicate the start and
end layers to be copied or deleted. The Layers' font color will change to green when
the layer is tagged. The message One Layer Tagged will appear in the status
message area.
Moving the cursor to different layers will include those layers in the tag. Pressing
F1 Tag Layer a second time will set the end tag marker. The tag will then include
the layers between the first tag marker and the second tag marker. A Layers
Tagged message will then replace the previous message. When the first tag is set,
another parameter, # Times To Copy, will display with a value of one. If the user
wants to copy the tagged layers more then once, the user can use the arrow keys
from the layer number column to this parameter. The user can change the value to
any number between 1 and 200.