Inficon HLD6000, Installation Manual

Page: 49 / 76

6 Operation
49
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
HLD
6000
, k
ina4
3
e1-
a
, 140
8
6.4.8.4 Deleting measured data
If the internal memory has no more available space for the data record then measured
data can be deleted.
1 Select " > Recorder > Delete".
2 Select the files you wish to delete.
3 Confirm your selection using .
6.5 Standby
The device switches to idle mode when you select the key in the measurement display
of the device.
Either pressing the key or pressing the button on the sniffer probe will reactivate the
device. If the device was in standby mode for more than 25 seconds, you can activate the
device by moving the sniffer line.
6.6 Diagnosis
Active warnings To display a list of current warnings, select " > Active Warnings".
Service The Service menu is password-protected. You can configure settings in the Service menu
only after completing a special training course from the INFICON service department.
Histories To receive information on errors and warnings which have occurred, select
"
> Histories > Error And Warning History".
To receive information regarding calibrations which were carried out, select the key
"
> Histories > Calibration History".
Update To initiate an update, select " > Update". For further information on this process see
"6.8 Updating the software", page 51 .
6.7 Calling up information about the device
It is possible to call up information regarding the parameters set and the operating modes
of the device.
1 Select the navigation key .
2 Make a selection by pressing one of the following keys:
– Basic unit
– COOL-Check
– I/O module
– Parameter list
– Sniffer line
– Operating unit
– Bus module
The stored device-specific information is displayed.