Inficon Fab UL6000 Fab, Operating Instructions Manual

Page: 61 / 152

INFICON Operation | 6
UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-02-(2207) 61 / 152
6.2.10 Set maintenance interval "Filter sniffer tip" or "Air filter"
To adjust the maintenance interval to the degree of contamination at the location of
the device, you can choose between a default value or a self-selected maintenance
interval.
ü Supervisor rights
1 > Setup > Maintenance counters
2 Adjust.
ð
Enter a value of your choice in hours for the "Filter sniffer tip" or press the
adjacent "Default value" button (1000 hours).
ð
Enter a value of your choice in hours for the "Air filter" or press the adjacent
"Default value" button (2500 hours).
3 Save .
After performing a maintenance, you should reset the desired period until the next
maintenance.
See also
2 Change the filter mat inside the tool box [ } 114]
2
Replacement of the filter mat on the bottom of the device [
}
115]
2
Replacing the SL200 sniffer line filter [
}
116]
2 Replacing the SL3000 sniffer line filter [ } 118]
6.2.11 Activate or deactivate maintenance requests
Enables or disables warnings when the time for maintenance is exceeded. The time
until the next maintenance is displayed.
ü
Supervisor rights
1 > Setup > Maintenance requests
ð In the “Enable/disable maintenance requests” window, you can activate or
deactivate the maintenance requests for the following modules:
- Calibration leak
- TMP
- Filter sniffer tip
- backing pump
- Exhaust filter
- Air filter
2 Adjust.
3 Save .