Inficon Ecotec E3000, Technical Handbook

Page: 49 / 146

Operation of the Ecotec E3000
3-11
ki
n
a
22
e c
h
ap
te
r 3
.fm
te
chn
ica
l ha
nd
boo
k
(1
20
6)
the message “please wait” will be displayed in the message line until a next
measurement is allowed.
Please confirm that the sniffer tip has been positioned properly by pressing the right
probe button so that the next measurement can be started.
After checking the pre-programmed number of locations, the result of the testing for
the total unit under test will be displayed as shown in the following screen shots:
The selected testing program as well as the gas type stored in the program will be
stated followed by the actual program cycle number.
The program cycle counter is increased by 1 after each completed cycle. The cycle
counter may be reset manually (in the Setup I•Guide menu, see section
4.5.4 ).
The cycle counter is also automatically reset on power off.
Next the summarized global leak rate is started. If the global leak rate is lower than
the global leak rate trigger the message "Global leak check okay!" will be displayed
followed by the testing results for each tested location.
If the summarized global leak rate exceeds the global trigger the message "Global
trigger exceeded!" will be displayed.
Fig. 3-12 I•Guide screens requesting the next location
Fig. 3-13 Result of I•Guide program: unit under test passed
Pos. Description Pos. Description
1 Program name 3 Cycle counter
2 Gas type 4 Results of each location tested