Inficon 580-000, Original Operating Instructions

Page: 48 / 128

6 | Operation INFICON
48 / 128 IRwin-Operating-instructions-mina66en1-15-(1904)
6.2.12 Configure data logging
You can record and store your survey with following data in the leak detector.
• Date
• Time
• GPS coordinates
Measurement data of the activated mode:
• CH
4
and CO
2
measurements
• % LEL
• CO, O
2
and H
2
S measurements (IRwin SXT and IRwin SXGT)
The measurement data recording must be configured before the initial use:
ü Login as Intermediate or Advanced
1 > > Data output > Log to File (Tab)
2 Select "Enable log to file" and press the button next to .
3 Select “Log interval” and select a time interval. A blue button is shown in the
lower right corner when data logging is enabled. Press the on / off button to start
and stop logging to file.
The shorter you set the recording interval the more disk space is required. The
percentage of disk space used is shown by the bar below, "Used disk space" on the
Log to File tab.
6.2.13 Enable dead band suppression (IRwin SXnn only)
For the toxic sensors in the application mode “Ex Tox mode“ a dead band suppression
can be activated. If you activate the dead band suppression, the leak detector will
suppress small signal fluctuations around the zero point of the measurement signal.
1 > > General > Misc (Tab) > dead band Suppression.
ð The symbols (top right) and (bottom right) appear.
2 Press the button next to .
6.2.14 Setting the Function Test Interval
Setting time interval for
Function Test
Reminder
Consider relevant standards and regulations.
ü Login as Intermediate or Advanced
1 > > Function Test > Interval (Tab)
2 Select the function test and the time interval.
ð IRwin S: You can set a time interval.