PIL – 01PM
PIL-01PM remote control has three keys:
Key ▲ “ up ”
Key ■ “ stop ”
Key ▼ “ down ”
Activating the blinds
To activate the motion of a particular motor, press the key ▲ “up”
(open) or the key ▼ “down” (close). You can stop the motor with the
key ■ “stop” at any moment.
Changing the batteries
The remote control is powered by one 3V button cell battery type
CR2032.
To change the battery, slide open the cover at the bottom of the remote
control. Replace with a new battery, with the plus (+) symbol facing up.
It is not permitted to dispose of waste equipment together
with other waste. Dispose only in specially designated areas.
The household plays a key role in the recycling of waste
equipment. By correct sorting of waste, including waste equipment and
batteries, household members ensure that the equipment is not disposed
together with household waste, but in specially designated areas, and
thus may be used again after recycling.
Contact:
P. I. E. INEL Sp. z o. o.
ul. Mostowa 1
www.inel.gda.pl
80-778 Gdańsk
16.10.2015
Registering the remote control
Operating with the PIL-01PM remote control is possible after having it
registered to a particular motor or controller.
In our devices we can distinguish the following ways to enter the
programming mode:
1.
First programming after turning on the power (radio
controlled motor, ST-01RL),
2.
Programming the ST-01R controller unit,
3.
Programming with the use of a registered remote control
(radio controlled motor, ST-01RL, ST-01R).
First programming with radio controlled motors
and ST-01RL controller units:
-
connect 230V AC power to a particular motor/controller,
-
in the next 10 seconds after turning on the power,
simultaneously short press the keys ▲ “up” and ▼ “down” of
the remote control (up-down arrows will appear on the
display),
-
the motor will execute the movement up and down,
-
in the next 10 seconds short press the key ▲
“up”,
-
a short movement up and down will confirm proper
registration.
NOTICE: This procedure will reset the motor and erase all the
previously registered remote controls.
Programming the ST-01R controller unit:
-
press the programming key S1 – the diode will flash once and
will glow permanently,
-
next short press the key ▲ “up” of the remote control,
-
the controller will signalise the registration of the remote
control with the diode flashing green and red.
With the use of a registered remote control:
Other remote controls are registered without turning off the power. With
the use of a registered remote control enter the programming mode of a
motor/controller:
-
simultaneously short press the keys ▲ “up” and ▼ “down” of
a registered remote control,
-
the motor will execute the movement up and down; next it will
execute a series of short movements up and down equal to the
number of registered remote controls,
-
in the next 10 seconds short press the key ▲
“up” with a new
channel or of a new remote control,
-
the motor will execute a series of short movements up and
down confirming the registration of another channel.