19
•
It should not show any signs of cable damage or wear that
could lead to a hazardous situation. In this case,
special maintenance is essential.
•
Replacement of gaskets and O-rings is essential for maintenance.
•
Gaskets and O-rings damaged during maintenance
may cause serious problems in product performance,
so be sure to replace them with genuine parts guaranteed by
the manufacturer.
•
It must be managed regularly so that dust does not accumulate
more than 5mm on the surface of the product through routine
cleaning. (To prevent static electricity)
•
Tempered glass glass should be cleaned with mild soapy
water diluted with water.
•
Germanium glass should be cleaned carefully to avoid scratching
or damaging the carbon-coated surface.
•
Damage to the germanium glass coating may reduce the UV
transparency of the surface.
•
When cleaning the germanium glass, loosen the bolts on the
germanium glass protector grid, clean it with mild soapy water
diluted with water, and then assemble again.
•
The surface of the device must be cleaned with a damp cloth.
Replacement of wiper
•
In the case of models equipped with a wiper, the blade may be
worn and the image quality may deteriorate. In this case,
you can replace the wiper blade by loosening the bolt that secures
the wiper blade and pulling it by hand as shown in the figure.
•
When replacing, if the wiper blade is pushed from side to side
severely, the wiper motor may fail.
※ Wiper Blade SET
IVEX Series Explosion Proof Camera Manual
Maintenance
Parts used for maintenance of the device are guaranteed by the manufacturer.
The manufacturer guarantees only the use of genuine parts.
Summary
Cleaning
Disposal of replaced parts
•
Disposal of the device must be properly disposed of in
accordance with the Electronic Waste Directive and
environmental regulations.
