14
Camera self-installation
Open Camera Housing Cover
•
For camera mounting, remove and store 8EA of M5*10
wrench bolts on the camera housing cover using L wrench (M4).
•
To open the camera housing cover of the product,
use the M4*40 wrench bolt provided as a component as shown
in
②
and fasten it to the 2 points of M3 thread.
•
Tighten two M4*40 wrench bolts with an L wrench (M3) alternately,
so that the camera housing cover is little by little away from
the body.
•
When a certain part of the camera housing cover is far from
the body, pull the camera housing cover by hand as shown
in
③
to completely separate the camera housing cover.
IVEX-FZ Series Camera Mounting and
Cable Connection
•
As shown in
①
, fasten the camera and camera bracket using the
bolts built into the product.
•
Insert the camera into the IP bracket as shown in
②
and fasten the camera connected to the bracket as in
①
with the tempered glass as close as possible using the bolts built into
the product when shipped from the product.
•
As shown in
③
, pass the cable through the NPT Entry of the
camera housing body and connect the camera's Power, CVBS,
and LAN terminals.
•
Depending on the product, the shape of the camera bracket and
IP bracket may change, but the mechanism for fastening the camera
is basically the same.
•
As shown in
④
, pay attention to the cable and the direction
of the camera housing body and assemble in the reverse order of
disassembly.
②
③
①
IVEX Series Explosion Proof Camera Manual
①
④
②
③
LAN
Power
CVBS
When replacing or installing the camera, be sure to work in a safe area
outside of the explosion-proof area.
