Indian Motorcycle SCOUT BOBBER 2021, Owner'S Manual

Page: 46 / 162

ITEM INSPECTION PROCEDURE
Headlamp The headlights automatically operate whenever
ignition switch is in ON position. Once headlamp
illuminates, switch to high beam. Verify that the high
beam indicator comes on and that lamp brightness
increases.
Taillight/
Brakelight Verify that the taillight and license plate light
illuminate. Verify that the taillight lamps increase in
brightness when the front brake lever is applied and
also when the rear brake pedal is applied.
Turn
Signals
Move the turn signal switch to the left. Verify that
front and rear left turn signals flash, as well as the
corresponding light on the indicator panel. Move the
switch to the center position and push it inward to
cancel the signal. Verify that the signals and the
indicator light stop flashing. Repeat the procedure
for the right turn signals.
Hazard
Warning
Flashers
Press and hold the hazard warning flashers switch for
1-2 seconds to activate the hazard warning flashers.
Verify that all four turn signals flash, as well as the
lamps on the indicator panel. Turn the hazard
warning flashers off. Verify that all signals and
indicator lamps stop flashing.
Horn Press the horn switch. Verify that the horn sounds
loudly.
Neutral
Indicator Place the transmission in neutral. Verify that the
neutral indicator lamp illuminates and that the letter
"N" displays in the gear position display.
ITEM INSPECTION PROCEDURE
Low Oil
Pressure
Indicator Start the engine. Verify that the low oil pressure
indicator is not illuminated.
Engine
Stop/Run
Switch
Start the engine. Move the stop/run switch to the
STOP position. Verify that the engine stops. Attempt
to restart the engine to verify that the engine WILL
NOT start.
GGEENNEERRAALL IINNSSPPEECCTTIIOONNSS
ITEM INSPECTION PROCEDURE
Engine Oil Check the oil level. See page 45.
Fuel Check the fuel level. See page 50.
Coolant
Level Check the coolant level in the recovery bottle. See page 69.
Fluid Leaks Check the vehicle and the ground/floor for any fuel, oil,
coolant or hydraulic fluid leaks.
Tires Inspect condition, pressure and tread depth. See page 46.
Brake
Operation Inspect pedal and lever movement.
Brake Fluid
Levels
Check front and rear brake fluid levels.
Brake
Compo-
nents Inspect hoses and connections.
Throttle Inspect hand grip and throttle movement.
Clutch Check lever operation and freeplay.
44
PRE-RIDE INSPECTIONS