5
Installation
NOTE: The rear of your cooker needs to be a required distance away from the wall.The two buffers at
the rear of the Hob determine this distance.
Splashback
A splashback is also supplied, to prevent food from falling down the back of your cooker.
To fit:
-
Remove the two buffers from the rear of the hob - retain to one side.
-
Position the splashback, as shown below.
-
Replace the two buffers to hold the splashback in position.
Siting the Cooker
The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space either
side need only be sufficient to allow withdrawal of the cooker for servicing and cleaning. It can
be used with cabinets one side or both as well as in an angled corner setting. It can also be used
freestanding.
Adjacent side walls which project above hob level, must not be nearer to the cooker than
150mm and should be protected by heat resistant material. Any overhanging surface or cooker
hood should not be nearer than 650mm.
Note: This appliance must NOT be fitted on a platform.
Moving the Cooker
Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.
Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the
oven roof, avoiding any grill elements.
Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor
covering is not damaged.
Levelling
Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level
the cooker.
The feet can be simply screwed in or out to lower or raise the cooker.
After the correct height is achieved, lock the feet into position by tightening the locking nut using an
open ended spanner.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.
NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.
Radio Interference
This appliance conforms to EN 55014 regarding suppression of radio and television interference.
