Golden Tee LIVE™
Version 9/16
Page 18
© Copyright Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
CHECK COIN DOOR CONNECTIONS
Your cabinet should already be wired correctly to the I/O Board’s connectors. Now is a good time to make sure
your game can accept money. Check the pinout chart in Appendix B for the correct wire colors and pins. Trace
the wiring to their sources and make sure they are connected properly and securely. Be sure the wires are away
from the coin door where they can be pinched or crimped.
CHECK HIGH-DEFINITION TELEVISION
Golden Tee LIVE supports a 1080p and 720p resolution that is compatible with newer HDTVs. Televisions with
lower resolutions are NOT supported. Refer to the Showpiece section of this manual for details on connecting
video and audio to a 1080p or 720p HDTV.
Note: Video and audio connections to these displays vary, and may require additional cables not included in the Golden Tee
LIVE kit. In addition, some televisions may not support the resolution needed for Golden Tee LIVE. Check your television's
manual for additional information.
WARNING: Be sure top of cabinet has at least 24 inches or 61 centimeters of clearance in all directions. Insufficient clearance
may result in damage to monitor or player injury.
REMOVE EXISTING CARD READER (IF APPLICABLE)
Golden Tee LIVE requires a new card reader, to take advantage of new credit card technology. To remove your
current card reader, open the coin door to access the card reader. Reach inside and disconnect the ribbon cable
from the Card Reader. Then from inside remove the four 11/32” nuts that hold the card reader to the inside of the
cabinet. Once loose, pull the card reader out through the front of the cabinet. If you are installing an Offline kit,
install the supplied card reader plate to cover this opening.
CUT HOLE FOR CARD READER
If your cabinet does not have a card reader installed, you must cut a hole to mount the supplied card reader. The
card reader is a very important aspect to Golden Tee LIVE, and is very important to keep in good working
condition. Players are required to use a card to identify themselves for most of the online features. If the card
reader is not working properly, these features will not be available.
Position the Card Reader Hole template found in Appendix H on the front of the cabinet, and as high up as
possible so players won't have to stoop over to insert their cards. Use an awl to mark the center of the four bolt-
holes and drill them to size. Use an electric handsaw to cut the rectangular opening to house the card reader.
VACUUM CABINET
The "new game look" should always apply to the inside of your game as well. A few wire ties and shrink tubing on
your harness, some fastening hardware on your subassemblies, and a thorough sweep with the vacuum cleaner
will help ensure that glitches do not occur.
Dust and dirt can damage your hardware and cause problems with game play. Be sure that your cabinet is clean
inside and out. It is highly recommended to vacuum your cabinet at least once a month, especially near the fans
and vents, to avoid overheating and costly repairs.
