• Before using the INCRA Miter V27, read and follow all of the instructions
and safety information in this document.
• When using the INCRA Miter V27 in conjunction with any other tool,
first read and follow all instructions and safety information in that
tool’s owner’s manual.
• When using the INCRA Miter V27, always keep your hands clear of the
cutter and the line of cut.
• Always turn off the power and make sure that the cutter comes to a
complete stop before changing the setting of any part of the INCRA
Miter V27.
• Always securely tighten the large black clamping knob before starting
any cut.
• Wear safety glasses, hearing protection, and follow all normal shop
safety practices.
• After making any adjustments to the miter angle of your INCRA Miter V27,
always verify safe clearance between the cutter and protractor before
turning on the power.
S
afety
Adjust the Miter Bar for a Perfect Fit in Your Miter Channel
Fig. 1
S
etup
1
Using the supplied 3/32” hex key, adjust each of the (3) visible miter bar
expansion disks for a zero-side play, sliding fit in your miter channel as shown
in
Figure 2
. Turning the fastener clockwise EXPANDS the bar width. The disks
are designed to require a fair amount of adjustment torque for proper ex-
pansion.
Fig. 2
2
Remove the large clamping knob and disengage the indexing tooth from
the protractor. Pivot the protractor head to access and adjust the fourth ex-
pansion point. See
Figure 3
. Replace the large clamping knob.
Fig. 3
3
w w w. i n c r a . c o m
Visit our website at
www.incra.com
for miter accessories along with
many other exciting and practical incremental woodworking tools.
MADE IN THE
USA
INCRA - MAKING ACCURACY EASY!
INCRA is a Registered Trademark of Taylor Design Group, Inc.
©2016 Taylor Design Group, Inc. Rev.06/16
Manufactured by:
Taylor Design Group
P.O.BOX 810262 Dallas, TX 75381
P: 972-242-9975 F: 972-242-9985
Miter Bar
Expansion
Disks for Miter
Bar
3/32” Hex Key
Protractor
Head
Large Clamping
Knob
Indexing
Tooth
Instructions
w w w.i n cra.co m
Retaining
T-clip
Place the V27 in your tool’s
Miter Channel.
NOTE:
If the
miter channel does not have
a T-slot, remove and save the
Retaining T-clip and screw lo-
cated at the end of the miter
bar as shown in
Figure 1
.
instructions
Adjust Final Disk
