EK-WL8-TRH/AU
WIRELESS TRANSLATOR
MODULE
STFV.425551.070-AU-UM rev. 4
20.08.2020
Page 12 of 22
FINAL STEPS OF INSTALLATION
Configure the radio system either directly with the translator’s
keyboard/display system or with a personal computer. System configuring
and programming will be described further in this manual.
ATTENTION
Due to limitation of short circuit isolators, the panel current
should be limited to 2 Ampere.
PROGRAMMING
ACCESS PERMISSION
Access into "Configuration" menu is possibility after password entering (de-
fault password- "33333"). To change default password is possibility through
"PSW Change" sub-menu which can find in path "Configuration"/"PSW
Change". To do this you should enter the Current password twice and then
New Password.
NOTE
In order to restore forgotten password you should do default factory
reset of the system. To do this you should push simultaneously 1 and 3 but-
ton and powered translator. After that on display should appear question
"Clear all?". Answering "Yes" all system will be cleared and will be restore
default password ("33333").
Summary of Contents for ekho EK-WL8-AU
Page 1: ...EK WL8 TRH AU WIRELESS TRANSLATOR MODULE STFV 425551 070 AU UM rev 4 20 08 2020 Page 1 of 22 ...
Page 6: ...EK WL8 TRH AU WIRELESS TRANSLATOR MODULE STFV 425551 070 AU UM rev 4 20 08 2020 Page 6 of 22 ...
Page 22: ...EK WL8 TRH AU WIRELESS TRANSLATOR MODULE STFV 425551 070 AU UM rev 4 20 08 2020 Page 22 of 22 ...
