Enter Setup
Exit and Save
20
3) How to Disconnect a Receiver
If you have paired the scanner with two different receivers, these two receivers can both
connect the scanner. If you want to disconnect one of them, please follow the steps below:
make sure the scanner is connected with the receiver that should be disconnected, and
then scan the barcodes in turn "Enter Settings" - "Disconnect Receiver" - "Save and Exit". The
scanner will disconnect from the receiver.
Disconnect Receiver
Wireless Bluetooth Mode
Bluetooth SPP Mode
Bluetooth SPP mode is not the default mode. To enter this mode, please read the barcode
“Enter setup”, “Bluetooth SPP Mode” and “Exit with save”.
Bluetooth SPP Mode
When switched to Bluetooth SPP mode, the BCST-55 will enter into Bluetooth broadcasting
mode and the blue LED indicator flashes. Then you can search the Bluetooth of BCST-55 and
get it paired on your phone/computer. After successful pairing, you need to run serial
debugging tool on your computer, and select Open Bluetooth COM Port. You will then hear
three chord sounds (from high to low) to indicate the successful Bluetooth connection.
Note: There might be two Bluetooth COM ports on the list. If the connection fails, please try
the other COM port.
Summary of Contents for BCST-55
