Enter Setup
Exit and Save
19
Code 39
Enable/Disable Code 39
(*) Enable Code 39
Disable Code 39
Transmit START/STOP Character
Enable Code 39 START/STOP Character
(*) Disable Code 39 START/STOP
Character
Checksum Code
The data in a Code 39 may not contain the checksum code. If there is, the
checksum code is the last character of the data. The checksum code is the value
added from all data collected, to check if the data is correct.
After you set the "Code 39 without Checksum" function, the scanner will recognize
all Code 39 normally. The scanner defaults enabling "Code 39 without Checksum".
After you set the "Enable and Transmit Code 39 Checksum", the scanner will take
the last digit of the Code 39 data output as checksum and transmit it as normal
data collected but won't be able to recognize Code 39 without checksum.
After you set the "Enable but Do not Transmit Code 39 Checksum" function, the
scanner will take the last digit of the Code 39 output as checksum but won't
transmit it. And it won't be able to read Code 39 without checksum.
(*) Code 39 without Checksum
Summary of Contents for BCST-53
