1. Insert the adapter into the USB port of your device such as a
computer.
2. Wait a few seconds and the driver will be installed automatically.
The adapter will be paired with your scanner automatically and it
only works with some designated Inateck barcode scanners.
User Guide
2.4G Adapter
FCC Note
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the Users, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. —Consult the dealer or an
experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. such
modifications could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure
requirement.
This equipment complies with FCC's RF radiation exposure limits set
forth for an uncontrolled environment. This device and its antenna(s)
must not be co-located or conjunction with any other antenna or
transmitter.
