In-situ RDO PRO-X, Operator'S Manual, Page: 7 / 29

7
1 Probe
2 Cable end, twist-lock connector and RuggedCable System
Serial Numbers
The probe serial number is engraved on the side of the unit. The cap serial number is programmed on the memory chip inside
the cap.
Unpack the Probe
1. Remove the probe from the box and other packaging materials.
2. Unscrew the nose cone from the probe and remove the red protective dust cap from the sensor. Save the dust cap
for later use.
1 Dust cap
2 Nose cone
3. Remove the RDO cap from the storage sleeve.
4. Align the arrow on the cap with the index mark on the probe and firmly press the cap onto the probe, without
twisting, until it seals over the probe body.