Cheetah Pregius Camera with 10 GigE Vision Interface – User Manual
October 8, 2020
Page
63
of
170
Rev 1.0
Configuring an Ethernet Adapter
and Host Computer
For the best system performance, configure the following parameters of your network interface
card (NIC): Jumbo Frames (Jumbo Packets), Receive/Transmit Buffers, Interrupt Moderation Rate
to the values shown below. You also might need to disable antivirus software and Firewalls, turn
off power saving plan, and configure IP addresses for multiple NICs on the host computer.
Make sure that the version of your NIC driver is the most
recent one, update it if necessary. Using an outdated version
of a NIC driver might negatively affect the data transmission.
Parameter
Value
Jumbo Frames (or Jumbo Packets)
9000 (9014, 16K, or 9 KB MTU)
Receive Buffers (or Receiver Descriptors)
Maximum
Transmit Buffers
Maximum
Interrupt Moderation
Enable
Interrupt Moderation Rate (or Interrupt Throttling)
Extreme
For adjusting procedures, see the
Adjusting Jumbo Frames, Receive/Transmit Buffers, and
Interrupt Moderation Rate in Windows
The parameter names and configuring procedures depend on the adapter
model and manufacturer and may differ from the ones described in this
chapter. When adjusting the adapter parameters, select the ones that relate
to the parameters listed above. For more information, refer to the NIC
documentation.
