Cheetah Pregius Camera with GigE Vision
®
Interface – User Manual
August 27, 2019
Page
97
of
123
Rev 1.0
GevSCPD
Indicates the delay (in timestamp counter unit) to insert
between each packet for this stream channel.
GevSCDA
Indicates the destination IP address for this stream channel.
GevSCPSPacketSize
The stream packet size to send on this channel, except for
data leader and data trailer, and the last data packet that
might be of smaller size (since packet size is not necessarily
a multiple of block size for stream channel).
GevHeartbeatTimeout
Indicates the current heartbeat timeout in milliseconds.
GevTimestampTickFrequency
This 64-bit feature indicates the number of timestamp ticks
during 1 second.
GevTimestampControlLatch
Latches current timestamp counter into "Timestamp value"
register.
GevTimestampControlReset
Resets timestamp 64-bit counter to 0.
GevTimestampValue
Reports the latched 64-bit value of the timestamp counter
User Set Controls
Figure 62:
User set parameters
UserSetSelector
Points to User Configuration Set (Default, User Set 0…User Set 3) to
load into the camera or save into the camera’s non-volatile memory.
Default is the Factory Default Settings.
UserSetLoad
Loads the User Set specified by UserSetSelector into the camera
workspace (volatile).
UserSetSave
Saves the User Configuration Set 0 or 1 specified by UserSetSelector to
the camera’s non-volatile memory. The Default User Set is read only
and cannot be modified by the user.
UserSetDefault
Points to User Configuration Set, which will be loaded and made
active when the device is reset or after power is applied.
Event Control
Figure 63:
Event Control parameters
EventSelector
Selects which Event to signal to the host application (see
).
EventNotification
Activate or deactivate the notification to the host application of the
occurrence of the selected Event
