Cheetah Pregius Camera with GigE Vision
®
Interface – User Manual
August 27, 2019
Page
82
of
123
Rev 1.0
Image Format Controls
Provides information on the camera base resolution and output resolution.
Figure 48:
Image format control parameters
WidthMax
Maximum width of the image in pixels calculated after horizontal
binning, decimation, or any other functions change horizontal
dimension of image.
HeightMax
Maximum height of image in pixels calculated after vertical binning,
decimation, or any other functions change vertical dimension of image.
Width
Allows you to create an AOI: sets the output image width in number of
pixels (multiples of 8).
Height
Allows you to create an AOI: sets the output image height in number
of lines (multiples of 2).
OffsetX
AOI Offset in horizontal dimension: Enter the number of pixels to
offset the image output from the left edge of the image. The number
must be a multiple of 8.
OffsetY
AOI Offset in the vertical dimension: Enter the number of pixels to
offset the image output from the top of the image.
ConstantFrameRate
Allows you to enable Constant Frame Rate independent of AOI size.
PixelFormat
The number of bits of memory associated with each pixel. Options are:
Mono8, Mono10, Mono10Packed, Mono12, Mono12Packed,
BayerRG8, BayerRG10, RayerRG12, BayerRG10Packed,
BayerRG12Packed.
PixelSize
Number of bits per pixel in memory (8, 10, or 12 bits).
PixelColorFilter
Shows the color filter pattern.
TestPattern
Enables test patterns based on the following selections:
BwCheckerBoard, Grey, TapSegmented, GreyHorizontalRamp,
GreyVerticalRamp, HorizontalAndVerticalRamp, VerticalBars,
HorizontalAndVerticalRampMoving, Crosshair, IpxGevPattern (refer to
the section
