background image

1

Use - Liability

This height adjustable desk has electric motors and is designed for use in dry work areas only. The desk height is 

adjustable so that it can be positioned at the most ergonomically suitable height. Any other use is at user’s risk. 

Under no circumstances does the manufacturer accept warranty or liability claims for damages caused from 

improper use or handling of the desk frame.

Make sure there are no obstacles in the desk’s path. 
Make sure the desktop is not touching any walls. 
Make sure all cords are of appropriate length to accommodate the change in height. 
Children should only operate desk under adult supervision. 
There is a risk of injury and electric shock if not properly installed.
Keep liquids away from electrical components. 
Do not sit or stand on the desk frame. 
Do not crawl or lie under the desk frame. 
Do not place any object taller than 508 mm (20”) underneath the desk . 
Do not open any of the electrical components. There is a danger of electric shock.
This product is designed with a duty cycle of 10% (2min. on, 18 min. off). 
In the event of a power outage or if the power cord is unplugged, a manual reset may be necessary.
Weight capacity: 172 kg ( 380 lb )

1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
11-
12-
13-

Caution!

In the event of a power outage or if the power cord is unplugged, a manual reset may 

be necessary. Press the two arrows at the same time untill you hear the alarm ringing. 

Then, lower the table to its lowest position. Your desk is now ready to use.

Summary of Contents for The Essential-LTM-2L-GA/EL-1









Reviews: