IMPAX-SK 5
IMPAX-SK 5
Operation Manual
1. LCD color graphic display (5.7“)
2. Function selection keys
(current function of each key is
shown in the symbol box above)
3. Timing signal indicators 1 and 2
4. Operating mode selection with
indicator LED:
• MAN - mode (manual/set-up)
• AUTO 1 - mode (normal shift)
• AUTO 2 - mode (after hour shift)
• STOP (machine switched off)
5. Numerical keypad 0 - 9
(and optional alphanumerical entry)
6. E-key (Enter Key)
7. Key depressed together with the
MAN-key to allow change to the
sensor timing window. Enter new
start value and Press E-Key. Enter
new end value and Press E-Key.
8. C-key (Clear/change display mode,
Etc.)
1
Turn On (push button located on rear panel)
The display and the MAN-key light up. The
is ready. Start the machine
and check your parts. When okay, start the monitoring mode (Step 2):
IMPAX-SK 5
2
Press AUTO-key
Unit will move into automatic monitoring mode (green AUTO-light turns on). During
the first few machine cycles the monitoring limits (envelopes) will adjust to fine tune.
3
Process Failures (machine stops)
In case of process errors (e. g. force errors or counter stops), the machine will be
stopped by the
(the
light turns off and the red STOP light comes
on). The display's top line turns red and shows the error message and the time when
stopped.
IMPAX-SK 5
AUTO
4
Re-start after machine stop
- press the
-key (stop relays are released so machine can be jogged)
- eliminate the cause of the stoppage, re-start machine and check parts
- when parts are ok, press
again to return to monitoring mode
MAN
AUTO
C
Set the part counters
E
Set Sensitivity (S) ,Tolerance (
) and QL (Q-Limit)
Tol
- press function key
(counter C1 for order size will appear)
- to set press
(old value turns blue) and enter your desired new count
- confirm your entry with
. Actual count zeroes, confirm again with
- press any key to switch counter from stop active (
) to not active (-)
- use the buttons
,
or
to call up the other counters and then set them
C
C
E
E
2
3
4
- Press
and then a numbered key to move to the desired channel
- to adjust settings press the
key (the sensitivity box will turn blue)
C
- adjust envelop
setting (1=coarse, 9=fine, 0=channel is off) confirm with
- adjust
(1-9 allowed faults, 0= immediate stop) and confirm with
- adjust
(Quality Limit) to minimal acceptable limit and confirm with
sensitivity (S)
E
Tol.
E
QL
E
3
2
1
6
5
4
9
8
7
E
0
C
GHI
DEF
ABC
PQR
MNO
JKL
YZ
VWX
STU
-/.
AUTO1
AUTO2
STOP
MAN
SK 1
SK 1
1 2 3
4
5
6
8
1
2
Force Curves
236
/min
IMPAX-SK Technologies
I M PA X - S K Te c h n o l o g i e s
7