ImmersionRC vortex 250 pro, Instruction Manual

Page: 61 / 65

Q. What is the deal with the new LED board?
In early 2016, Vortex 250 Pros started shipping with a new LED board. This LED board
increases the LED count from 8 to 12, adds a diffuser to greatly increase visibility from the
side/top/bottom of the quad, and also adds the possibility for a solder-free connection to the
PDB.
This new board is available as a retrofit kit, part number ​ VXLED250 ​ .
Q. My motors are ‘stuttering’, and the quad falls out of the sky under full throttle
This is almost always due to motor screws touching the windings. Motor screw length on any
mini-quad is absolutely critical, especially for ‘upgrade’ motors which have extremely thin
base material.
Q. My R/C Receiver isn’t auto‐detected by the wizard
Normally, the 250 Pro will start up in a receiver ‘auto-detect’ mode which will automatically
identify the connected PPM/SBUS/DSMX. Receiver.
From time to time (for reasons not yet understood) this process fails. To work around this,
simply connect the quad to a PC/Mac and using the Vortex Configurator manually set the
receiver type.
Q. I don’t like the stock camera, and would like to upgrade it
There are a couple of ways to do this. First one is simple and involves a lense replacement.
61