ImmersionRC vortex 250 pro, Instruction Manual

Page: 50 / 65

Appendix B: The Wizard - What else does it setup?
On startup the wizard will reset Cleanflight configuration to its default state.
Once completed the following features, configurations and mode will be injected in
Cleanflight so you can start to enjoy your Vortex straight off the box with zero additional
configuration needed:
Flight Controller
Failsafe Enabled, Throttle set to 1100
OneShot125 Feature Enabled
Rx Mode PPM Sum Mode (all channels down a single cable)
Minimum Throttle 1100us
Maximum Throttle 1900us
Minimum Command 1015us
Angle mode on Aux1 1300 - 1700us
Horiz mode on Aux1 900 - 1300us
Acro mode on Aux1 1700 - 2100us
Channel Mapping According to Wizard prompts
Accelerometer Calibrated at wizard end
Pro-Tuning Default ImmersionRC settings (based on UmmaGawd’s tune)
NOTE: If you have ‘tweaked’ any Cleanflight settings outside of the Vortex OSD, please
remember to back them up before running the wizard the next time, since it will reset
them to default settings.
50