MI07A592-Rev1011-GB
1/4
FIRE/503 WATER-N
ELECTRONIC CONTROLLER FOR
FIREPLACES
INTRODUCTION
We thank you for your trust and congratulate you for choosing
one of our products. This device is a BUILT-IN ELECTRONIC
CONTROLLER FOR FIREPLACES that manages four devices
through microprocessor logic: two circulators, one diverter
valve and one auxiliary output.
COMPLIANCE WITH STANDARDS:
•
EN 60730-1 as subsequently amended
•
EN 60730-2-7
•
EN 60730-2-9
COMPLIANCE WITH DIRECTIVES:
•
B.T. 73/23/EEC
•
E.M.C. 89/336/EEC
as subsequently amended CE 93/68/EEC
TECHNICAL CHARACTERISTICS
POWER SUPPLY = 230Va.c./50Hz (+10%-15%)
TEMPERATURE PROBE = NTC 1%
MAXIMUM PROBE TEMPERATURE = 150°C
OPERATING TEMPERATURE = 0÷50°C
STORAGE TEMPERATURE = 0÷60°C
OPERATING HUMIDITY = 10%÷90% with no condensate
ADJUSTMENT = with relays (I max. = 3A)
ABSORBED POWER = 1VA
LCD DISPLAY
TEMPERATURE DISPLAY = 5÷85°C (1°C resolution)
DEGREE OF PROTECTION = IP20 (installed product)
INSTALLATION CONDITIONS = normal environment
ASSEMBLY = in standard 3–module flush-mounted box DIN503
NON-VOLATILE DATA STORAGE ON FLASH TECHNOLOGY
KEYPAD = in rubber with 8 keys
BUZZER internal for alarm signalling
CONTROLS LEGEND
+ / - keys
Increases or decreases the selected value
SET key
Enables the SET Point function
E key
Enables the Enter function
A key
Enables the Automatic function
T button
Press T to store the new parameters
OFF key
Press OFF to turn off the controller
DIMENSION
INSTALLATION AND CONNECTIONS
SAFETY INSTRUCTIONS
•
Before you connect the controller to the mains, make
sure that voltage is CUT OUT and that it corresponds
to a value of 230Va.c.
(Fig. 3).
•
The fireplace must be connected to the mains, with a
line
differential main switch
, in compliance with regulations
in force.
Make sure that the electrical characteristics of the motor to be
controlled are compatible with those of the product
(Imax=3A).
The manufacturer is not liable for improper use of the device.
POSITIONING
•
Do not install in places where temperature can exceed
40°C
(Fig.4)
•
Make sure the box is expressly intended to contain the
product only, and that it is NOT used as a shunt
(Fig.5)
INSTALLATION
A)
Connect the wires to the terminal boards as shown in the
electrical diagram (see paragraph “electrical wirings” and
“application diagram” below)
B)
Fit the controller inside the 3-module box previously
mounted within the wall, and secure everything using the
screws supplied with the product
Fig. 3
Fig. 4
Fig. 6
Fig. 1
Fig. 5
Fig. 2
