7
English
Français
Français Page
Italiano
Italiano Pagina
Español
Español Página
English
English Page
Wireless Hand-Held Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
All operating elements described can be found
on the fold-out page 3 .
1 Overview
1.1 Fig. 1: Hand-held microphone
1
Microphone cartridge; to insert batteries, un-
screw the cartridge (figs . 2 to 4)
2
LC display; shows the transmission channel
and the charging status of the batteries during
operation
3
Cap for the control part; remove the cap for
operation (fig . 5)
4
Power switch
1.2 Figs. 2 to 4: Inserting batteries
(microphone cartridge unscrewed)
5
4-pole contact, each on the microphone car-
tridge (fig . 2) and on the handle (fig . 3);
prior to assembling the microphone cartridge
and the handle, interconnect the contacts
6
Lock for the battery holder (7);
to unlock the holder, push the lock to the rear
in arrow direction
7
Battery holder for two 1 .5 V batteries of size
AA (R6)
1.3 Fig. 5: Control part
(cap removed)
8
Key SET
with the unit not locked:
to call and to exit the adjusting modes for
channel / sensitivity/ lock function
☞
chapters 5 .1, 5 .2 and 5 .3 .1
with the unit locked:
to call and to exit the adjusting mode for the
lock function
☞
chapter 5 .3 .2
9
Key
for channel selection “down” (in the
channel adjusting mode), to reduce the sensi-
tivity (in the sensitivity adjusting mode), and to
deactivate the lock function (in the lock mode)
10
Key
for channel selection “up” (in the chan-
nel adjusting mode), to increase the sensitivity
(in the sensitivity adjusting mode) and to acti-
vate the lock function
2 Important Notes
This unit corresponds to all relevant directives of
the EU and is therefore marked with .
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity and heat (admissible ambient tem-
perature range 0 – 40 °C) .
•
For cleaning only use a dry, soft cloth; never use
chemicals or water .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it
is not correctly operated or not repaired in an
expert way .
If the unit is to be put out of operation
defini tively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .
3 Applications
In combination with the 2-channel multifrequency
re ceiver TXS-895 from IMG STAGELINE, this dy-
namic hand-held microphone with integrated mul-
tifrequency transmitter creates a wireless audio
transmission system . Within the UHF frequency
range of 518 – 542 MHz, the transmission channel
can be se lected as desired among 16 channels .
The microphone is supplied with a microphone
case, a microphone holder and 7 push-on caps of
different colours .
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare that
the wireless microphone TXS-895HT complies with
the directive 2014 / 53 / EU . The EU declaration of
conformity is available on the Internet:
www .img-stageline .com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
DE
EL
FI
FR
IT
LT
MT
PL
In the Federal Republic of Germany, the wireless
microphone requires a
frequency assignment
(for which a fee is charged) . In other countries, it
is necessary to apply for a corresponding approval .
Prior to operating the unit outside Germany, please
contact the MONACOR subsidiary or the corre-
sponding authorities of the respective country .
