E190601X rev.6_ENG
May 30, 2022
8
Remove the side panel and the side and proceed to remove the latches.
All panels must be reassembled in the original position before the machine can be started. After removing them,
the retainers must be stored and reused whenever the machinery is to be transported. Transport stops are not
present in rigid washer-washing machines.
5. INSTALLATION AND POSITIONING
All positioning and installation operations must be performed by professionally qualified personnel and
according to the instructions in the relevant installation manual.
ATTENTION!
If the machine cannot be installed respecting the criteria below, it is necessary to request the appropriate
transformations from the manufacturer.
Please note that for proper use, operation, and maintenance, you must leave a free space of at least 600 mm
around the machine. For battery machines, for example in self-service installations, the necessary side space
can be reduced to 10mm.
The ambient temperature must be b5°C and +40°C.
The smooth operation of the machinery is guaranteed in environments where the residual humidity is not higher
than 50% at a temperature of +40 ° C.
The environment in which the machinery is installed must have sufficient air exchange.
The machinery may not be installed at altitudes above 1000 m above sea level.
The degree of protection is IP24.
ATTENTION!
Do not use or store gasoline, petroleum or other flammable materials in the vicinity of the car. It could cause
fires or explosions.
ATTENTION!
In the case of tilting machines there are external elements of the machine itself, moving during the loading and
unloading phases of the linen.
For the dimensions of the machine and the moving elements in the different positions, refer to the technical
sheet.
