E190601X rev.6_ENG
May 30, 2022
35
35. USE OF THE TILTING MACHINE
To the description of the previous paragraphs must be added the following clarifications, in the event that the
machine is equipped with a system for tilting the basket forward and / or backward.
The removal of the transport and locking stops of the tank must be done following the instructions given in the
appropriate paragraph.
The pneumatic controls are managed via a remote push-button panel to perform the forward lifting (unloading
phase) or the rear lifting (unloading phase).
It should be noted that the machine, depending on the option applied, can have the availability of only tilting
forward, only tilting back or both.
The description, from here on, will be related to the machine equipped with both drives.
ATTENTION!
When the machine is in the process of tilting, or pneumatic opening of the door (where present), the operator
must keep out of reach of the machine and the porthole, using the appropriate remote-control panel.
The user must pay attention to the dangers of crushing and shearing between the overhead elements and the
other machines or structures of the building!
When the tilting phase is not active, the "CRADLE UNLOCKED / CRADLE UNLOCKED" LED is lit on the machine
front.
ATTENTION!
During tilting operations, the porthole must be locked with the appropriate latch, so as to prevent the porthole
from tilting freely while the machine rises or falls.
The tilting phase can only be activated if the porthole is open.
To activate the tilting function, you need to hold the remote control with both hands and activate it via the
selector which must be brought from position "0
” to
position "1".
When the remote control is activated, the green LED on the keyboard lights up.
From here on, the use of remote-control buttons will be described.
ATTENTION!
Reach button of the remote control will work, if and only if it is pressed at the same time as the green button
present in the remote control itself.
Before allowing the tilting movement, it is necessary to carry out the locking of the cradle. It is therefore essential
to hold down the "CRADLE LOCK / CRADLE LOCK" button, until the green LED on the front of the machine lights
up.
At the same time, both LEDs must also be lit:
-
"FORWARD ENABLED TILTING"
-
"BACKWARD ENABLED TILTING"
Only after that, you can activate the lifting of the machine:
-
forward (NEXT
–
UP / FORWARD-UP)
-
backwards (BACK
–
UP / BACKWARD-UP)
by pressing the corresponding keys on the remote control.
ATTENTION!
Durante the movement in FORWARD / FORWARD, only the LED "TILTING FORWARD ENABLED / FORWARD
ENABLED" will remain lit.
