E190601X rev.6_ENG
May 30, 2022
30
appears on the dirty side.
Touch the touch at the inscription: the basket rotates until the inner door is brought back to the porthole of the
dirty side, ready for the next program.
ATTENTION!
For barrier machines (double door): before closing the external porthole, make sure that the internal door has
been closed correctly, according to the procedures indicated with a special notice on the machine itself.
In case of incorrect closing of the inner door, the cycle MUST NOT be started.
Make sure that the operators have well understood the instructions for closing the internal door on board the
machine!
28. END OF WORKING DAY
At the end of the working day, the machine must be brought to the end of the cycle and turned off: the basket
must be emptied and cleaned.
Turn off all power supplies by operating the relevant line switches/disconnectors: electric, steam and
compressed air.
Finally, leave the porthole open.
29. PROGRAMMING
The programming procedure allows you to modify existing programs or to implement new programs.
A program consists of a sequence of steps or steps, configurable in detail, in the various parameters that
compete with them.
Use the instructions published online.
30. DISPLAY REPORTS
The computer provides complete diagnostics both in case of malfunctions and in the case of simple reports.
Below is the list of reports that may appear on the display. However, the user is invited to contact, in these cases,
an authorized service center for the solution of the problem occurred.
COD
DESCRIPTION
WHAT HAPPENED: WHAT TO DO
1
THERMAL MOTOR
A display appears: "ALARM !!! 01 Thermal Engine".
The machine stops and the buzzer rings for 15 seconds.
When you touch the touch, the alarm is reset and the door opens.
An overheating of the engine has occurred: wait for the engine to cool down
and restart the cycle. If the problem occurs often, call the Authorized Service
Center.
2
OBLO' OPEN
A display appears: "ALARM !!! 02 Open Door".
The machine stops and the buzzer rings for 15 seconds.
When you touch the touch, the alarm is reset and the door opens completely.
The porthole opened while a cycle was in progress. Call the Authorized Service
Center.
