SubVIS Orca II - User Manual
IMENCO AS
Visiting Address:
Kophaug 3, 5570 Aksdal, Norway
Office: +47 52 86 41 00
Org No: 923 005 749 MVA
Mail Address:
PO. Box 2143, 5504 Haugesund, Norway
Fax:
+47 52 86 41 01
www.imenco.com
4
Contact
for assistance / clarification on any of the contents of this manual, please contact:
Imenco AS
Subsea Electronics
Kophaug 3
5570 Aksdal NORWAY
Tel: +47 52 86 41 00
E-mail: [email protected]
Safety information
IMPORTANT!
The Imenco SubVIS Orca II camera is a technically advanced product. Please make sure
to read and understand all sections of this manual before installing or operating this product.
Installation of this product should only be performed by qualified personnel.
WARNING!
This product contains no user serviceable parts.
Do not open, alter or disassemble this product.
Failure to comply with this warning can result in damage to equipment and void of warranty. The
camera is filled with inert gas at manufacture.
WARNING!
The housing is NOT connected to any Protective Earth circuits.
The metal housing has no electrical contact with any of the circuits inside the camera. This is to
isolate the camera housing from other equipment that includes dangerous high voltage and to
minimize corrosion that otherwise might be intensified by electrical contact to other nearby metal
equipment or structures exposed to the sea water.
Warranty
Be sure to read and comply with
Imenco’s Terms & Conditions
that the SubVIS Orca II camera
product was sold under.