imenco SubVIS Orca II Subsea Camea, User Manual, Page: 17 / 24

SubVIS Orca II - User Manual
IMENCO AS Visiting Address: Kophaug 3, 5570 Aksdal, Norway Office: +47 52 86 41 00 imenco@imenco.com
Org No: 923 005 749 MVA Mail Address: PO. Box 2143, 5504 Haugesund, Norway Fax: +47 52 86 41 01 www.imenco.com
17
4.4.2 Subsea connector type and pin-out
Figure 7, Orca II camera - standard connector and RJ45 plug with T568B colors
The Orca II camera standard subsea connector is SubConn® D DLSAM
The wires from this connector internally in the camera are color coded and connected to terminals of
the camera electronics as indicated in Table 4. The Ethernet twisted pairs are terminated according
to T568B as shown with an image of a RJ45 plug in Figure 7 and color names in Table 4.
Orca II camera
Internal electronics SubConn® DBCR-13-M:
Terminal Description Number Internal Wire color Conductor
Power in Minus J12 PWR − Black 1 DC Power
Not connected Orange (screen) 2
Power in Plus J12 PWR + White 3
BI-DA + / Tr RJ45-1 White/Orange 9 Twisted
pairs
T568B
color
scheme
BI-DA - / Transmit - RJ45-2 Orange 8
BI-DB + / R RJ45-3 White/Green 11
BI-DC + RJ45-4 Blue 6
BI-DC - RJ45-5 White/Blue 7
BI-DB - / Receive - RJ45-6 Green 10
BI-DD + RJ45-7 White/Brown 5
BI-DD - RJ45-8 Brown 4
RS232 TxD * J13-2 Red 12 Optional
use
RS232 GND * J13-6 Green 13
Table 4, Orca II camera standard subsea connector pinout (Ethernet connected as T568B)
The Orca II camera is powered by an adequate DC source (24 V , minimum 20W ) connected with
polarity and pin numbers as indicated in Table 4.
*) The galvanic isolated RS232 output is optional and could be replaced with RS485 or GPIO(0-5V).