These are instructions for swapping the extruder stepper motor wire pairs on a Clay DeltaWASP
3D printer.
This part replacement will require the use of safety knife, a pair of tweezers.
Before you begin, do the following:
•
Turn off the DeltaWASP 3D printer
•
Unplug power and USB cables
1. Disconnect the clay extruder connector shown in the picture.
2. Use a safety knife or a blade to carefully cut and remove the heat shrink tube as shown in the
picture. Make sure to cut the heat shrink very gently to avoid cutting the cable wires.
1
