Imagine Versio, Installation Manual

Page: 36 / 78

34 Chapter 2 | System Installation
Ve r s i o H a r d w a r e I n s ta l l a t i o n M a n u a l
© 2015 Imagine Communications
Proprietary and Confidential
Install Hard Drives
The Versio comes equipped with hot-swappable hard drives. Only Harris
Broadcast qualified HDDs are recommended for use in Versio chassis.
Remove Hard Drive Trays from the Chassis
1 Press the release button on the drive carrier. This extends the drive carrier
handle.
2 Swing the handle out fully and pull the tray straight out.
Figure 2-1. Tray Removed from Chassis
Install Hard Drive into a Drive Carrier
1 Remove the four Phillips head screws holding the dummy drive to the
carrier and discard the screws.
Note:
The screws used to secure the dummy drive to the tray cannot be
used to secure the hard drive.
2 Insert your new drive into the carrier with the PCB side facing down and
the connector end toward the rear of the carrier.
3 Align the drive in the carrier so that the mounting holes of both are
aligned.