Imagine Selenio X50, Installation And Operation Manual, Page: 54 / 136

Chapter 3
Controls
40
Figure 3-13. 16:9 to 16:9 Conversion
AFD/VI/WSS Alignment
The following settings are required to enable AFD/VI/WSS alignment:

The menu option Video >Data > (SDI1 Output/SDI2 Output) > (AFD Control/VI
Control/WSS Control) must be set to Insert Auto . This is the mode in which the AFD/
VI/WSS code embedded at the output reflects the ARC setting applied to the video.

The menu option Video > (Scalar1/Scalar2) > ARC Preset must be set to either AFD,
AFD-ALTR , VI , VI-ALTR , WSS, or WSS-ALTR . These are modes in which the ARC
setting applied to the video follows the code present in the input signal.
16:9 to 16:9 conversion
Conversion
(Alternative)
Conversion
Illustration in a
16:9 coded frame
>16:9 in 16:9
AFD Code: 0100
AFD and VI Select
parameter options
16:9 A 4:3
AFD Code: 1111
14:9 P
AFD Code: 1011
4:3 P A 14:9
AFD Code: 1101
16:9 A 14:9
AFD Code: 1110
16:9 Full
AFD Code: 1000
16:9 Prtctd
AFD Code: 1010
4:3 P
AFD Code: 1001
None
WSS name
None
None
None
None
Anamorphic
None
None