Imagine Selenio X50, Installation And Operation Manual, Page: 31 / 136

X50
Installation and Operation Manual
17
Note: The light on the Remote button flashes while the unit is remotely controlling a
device.
6 To switch to another unit, or to control the local device you are physically operating, press
the
Remote button , and then select a new device to control.
7 Select <local device > to resume normal single-unit operation.
Configuring for Web Browser Control
The control interface allows up to 10 simultaneous monitoring connections. Each
connection shows device fault and parameter information. When a change occurs to a
device, such as a fault or a parameter change, that change will appear on the monitoring
screens of other users.
Note: Navigator version 4.6 no longer supports a specific GUI for the X50. Instead, a
Silverlight web server launches when you click on a code-updated X50 in Navigator.
System Requirements for Device Monitoring
The computer used to monitor and control an X50 must meet or exceed the following
hardware and software requirements:

An X50 frame installed and connected to the LAN

A PC connected to a LAN with:

Operating System: Windows 7,Windows Vista; Windows XP Service Pack 2

Intel® Pentium® III 450MHz or faster processor (or equivalent)

A minimum of 128MB of RAM

A standard crossover or straight-through100 Mbps 100Base-T RJ-45 Ethernet cable to
connect to a PC (the frame auto-detects the cable type)

JavaScript enabled web browser; for best results use Microsoft Internet Explorer 8.0

Silverlight version 4.0

Quicktime version 7.6.8