Imagine Selenio X50, Installation And Operation Manual, Page: 121 / 136

X50
Installation and Operation Manual
107
Version 2 and 3
Versions 2 and 3 feature a separate front cover and lid. Follow these steps:
1 Disconnect both AC power cords.
WARNING: You can receive an electric shock from exposed parts of the power
supplies. Ensure that you remove AC power from both power supplies before you
open the cover.
2 Remove the 9 screws from the X50 lid.
3 Lift the cover straight up and off the frame.
The power supplies are now accessible for servicing. For other replacement parts,
continue with the following steps.
4 Remove the 9 screws from the top and bottom of the dark grey front cover (do not remove
screws from the side mounting ears).
5 Pull the scrolling knob straight off its shaft and then carefully slide the front cover off the
unit.
CAUTION! Do not tilt the frame as you remove the cover. Damage may occur.
6 After you have completed servicing the unit, reverse steps 1 to 5.
As you replace the front cover, take care to gently re-insert the flexible LED tubes.
Use a pin to help re-insert the light tubes back into their slots. Do not attempt to adjust
the LEDs located on the left side of the control panel (these are fixed circuit board
LEDs).
Figure C-2. Re-Aligning Flexible Light Tubes