4
DA-DHR/DH/DSR/DS/HR/H6802
+
Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 1: Introduction
•
Enable automatic switching input between input 1 and input 2 in the
1×8 configuration when a loss of the input signal is detected
•
Input signal presence detect and report
•
Automatic input cable equalization
•
Maximum equalized cable length adjustable (remotely only)
•
Direct fanout the input signal (5 Mb/s to 540 Mb/s) without
reclocking
•
Card-edge control by jumpers with LED display
•
Remote control via RS-232 or Ethernet
DA-
•
One input, eight outputs
•
Input signal presence detect and report
•
Automatic input cable equalization
•
Maximum equalized cable length adjustable (for 270 Mb/s and
remotely only)
•
Reclocking Mode selectable as automatic or manual
•
Re-lockable for 270 Mb/s, 1.5 Gb/s and 3.0 Gb/s SMPTE signal
•
Re-lockable for DVB-ASI signal
•
Reclock status and rate report by LEDs
•
Reclocking Bypass mode is selectable as automatic or enforced
•
Card-edge control by jumpers with LED display
•
Remote control via RS-232 or Ethernet
DA-H6802+
•
One input, eight outputs
•
Input signal presence detect and report
•
Automatic input cable equalization
•
Maximum equalized cable length adjustable (for 270 Mb/s and
remotely only)
•
Direct fanout the input signal (5 Mb/s to 3 Gb/s) without reclocking
•
Card-edge control by jumpers with LED display
•
Remote control via RS-232 or Ethernet
Typical Broadcast and Production Applications
DA-DHR/DH/DSR/DS/HR/H6802
+
distribution amplifiers can be
used in broadcast, cable, production, educational, and auditorium
applications where a low-cost method of distributing dual channel
signals is required.