Selenio
TM
BNP User Guide, Release 3.7.1
129
- Grooming - Mapping
Figure 76.
Create Output Transport Stream (FAT ASI)
1.
At the
Create Output Transport Stream
(FAT ASI) dialog, set parameters.
2.
Click
OK
.
View results of this configuration at the
Outputs panel
(
) of the
Mapping
tab screen.
Table 67.
Create Output Transport Stream (FAT ASI)
Field
Description
Port
Read-only, Shows either ASI or GigE depending on the port selected.
Non-DPI
Enable (check) or disable (un-check) a Grooming-only (Non-DPI) license for
the TS.
TS Name
The (optional) name you want to assign to this output transport stream.
Bitrate (Mbps)
The bitrate at which the stream is transported.
Unique TS ID
Assign a unique numeric ID to this transport stream.
• When this option is
checked
, the TS ID value placed in this field will be
reserved as unique for the entire chassis.
• When this option is
unchecked
, a TS ID value may still be entered,
however the value may be the same as another TS ID as long as that TS
ID’s value has not been reserved as a Unique TS ID.
• Note that each TSID is a unique number used to identify a transport
stream. It is a partition of two 16-bit hex numbers. The lower 16 bits (user-
specified in decimal and converted to hex) is the MPEG transport stream
ID. The upper 16 bits (0x) is strictly used internally.
• Default value is “
1
” if no value is specified.
• Broadcasters must configure this value with a unique ID to meet FCC
standards.
Reserved B/W (Mbps)
Enter any bandwidth value to be apportioned to the transport stream.
Network PID
Decimal value to define the program ID on which the stream is received.
Note that display of this entry, in applicable screens, is dependent on the
current setting—as either hexadecimal or decimal—for
Configuration
--
>
Global PID Display.
