Imagine communications Selenio 6800 HUC6800, Installation And Operation Manual

Page: 27 / 84

HUC6800
+
Installation and Operation Manual 13
Chapter 2: Installation
Local and Remote Jumper Settings
Follow this procedure to set the REM/LOC jumper for either remote or
local control:
1. Locate the
REM/LOC control jumper on the module (beside the
mode select rotary switch). Figure 2-1 on page 12 shows the
standard location of the REM/LOC jumper.
2. Place a jumper on pins 1 and 2 to set the module for Remote
control, or pins 2 and 3 to set the module for Local control. See
Figure 2-2 .
Figure 2-2. REM/LOC Settings for Remote and Local Control
See Table 1-1 on page 5 for more information on local/remote control
jumper functionality.
Genlock Termination Jumper Settings
Follow this procedure to set the Genlock Termination jumper J1:
1. Locate jumper
J1 on the module, near the back of the module.
( Figure 2-1 on page 12 shows the location of the jumper.)
2. Place a jumper on pins 1 and 2 to set the module for No
Termination, or pins 2 and 3 to set 75
Ω
Onboard Termination
(see Figure 2-3 ).
Figure 2-3. Genlock Termination Settings
Note
You must configure modules for
local or remote operation
prior
to power-up. To change the
configuration, first remove
power from the module, reset
the jumper, and then reapply
power.
The white triangle near the
jumper pins on the module
indicates pin 1.
1 2 3 1 2 3
Remote control
Local control
1 2 3 1 2 3
No Termination 75
Ω
Termination