Imagine communications NEXIO NX1010 series, Hardware Manual

Page: 18 / 56

Chapter 1
Installation
14
To insert a new power supply
1 Slide the replacement power supply into the empty slot.
2 Press firmly so that it clicks in place. If the power supply cord is in place,
the module's status LED will illuminate.
Mouse
There is a port designated for use with a PS2 mouse.
Keyboard
There is a port designated for use with a PS2 keyboard.
USB
There are four available USB 2.0 ports. Two USB ports are located on the
front panel. Two USB ports are located on the rear panel of the NX1010
series.
All USB ports can be used to connect devices to the NX1010 series.
The following USB devices can be used as sources and destinations when
moving content in and out of the NX1010 series:
„
USB CD-ROM/R/RW drives
„
USB DVD-ROM/RW/RAM drives
„
USB hard drives
„
USB removable disks
An FTP site created for a USB device is created as Folder type rather than
an FTP Server type.
VGA
The NX1010 series has one VGA port. This lets you connect a monitor to
the system.