Setup & Operator Manual Compass Product Line
L610-0220 REV A
10
CLEANING STEPS FOR COMPASS PRODUCTS:
a)
Wipe off any excess fluids with a water dampened cloth or sponge.
b)
Clean the Compass Product metals using an approved cleaner listed above.
c)
Clean the articulating arms and components from either the ceiling mount or mobile
platform systems with Simple Green ™ cleaner as needed.
CLEANING STEPS ACRYLIC WINDOWS:
a)
To Clean, stay away from abrasive tools and cleaners. Us a mild, non-abrasive cleaning
solution, soft cloth, and careful minimal pressure motion.
b)
Clean using a microfiber or non-abrasive damp cloth. Either wet the cloth directly in the
soapy mild water solution, or moisten it completely before using.
c)
Always use a new, clean cloth to wash. Never use a cloth used for another cleaning job
for this could scratch the acrylic. Approved cleaner listed above.
d)
Do not use paper towels, scrub pads, or other abrasive cleaning tools.
For repairs or replacement of components, please contact Image Diagnostics for Service and
Repair at (978) 829-0009.
All maintenance procedures should be done by an experienced and qualified technician with
demonstrated knowledge and skills (mechanical) in the service of medical equipment.
✓
This individual must have access to this manual and the proper tools.
✓
Lubrication of this device is
not
required.
RECOMMENDED PERIODIC PERFORMANCE CHECKS
Daily (Prior to use)
Inspect all surfaces for procedure use
contamination. Refer to general cleaning
instruction, Section 9
Quarterly
Visually inspect all components, loose
hardware and the shielding for wear and
damage. Maintain as needed.
10.
Service & Repair
11.
Maintenance
