/
Page 140
Setup Manual
The test sequence will take approximately 30 seconds.
After scanning, the image will not be displayed.
A small window – depending on the browser used for scanning – opens.
Select between opening the image with an appropriate software application and saving
the image.
The default image name contains the test target name, the device type and the serial
number of the scanner.
Picture 129 shows as example the window of the Mozilla Firefox browser.
Picture 129: Request after scanning the test target
The file name contains some information about the test target and the scanner. The
example is taken from a
Book
eye
®
scanner.
CSTT-FLAT-BE4-SGS-V2-00199976fc94
CSTT:
Test target name.
FLAT:
Specifies the selected focus mode. Other focus modes available, depends
on the scanner.
BE4-SGS-V2: Device type. Here
Book
eye
®
4
, version SGS-V2.
00199976fc94: Serial number of the scanner.
This information is helpful for service technicians to find the scanner specific data in the
database.
The test target image contains information which allows analysis of the current settings of
the scanner and comparison with the factory settings.
Summary of Contents for WideTEK 48
Page 1: ...Setup Manual ...
Page 2: ...File WT36 48 600_SetupManual_D docx ...
Page 17: ... Setup Manual Page 17 ...