Setup Manual
Page 113
E.7 Administrative Settings
E.7.1
Wake up Remote Host
If an external PC is used with the scanner, it is helpful to start the PC at the same time
when the scanner starts.
This can be done by activating the
Wake up Remote Host
function.
Picture 109: Wake up Remote Host
The requirements for using this function:
•
In the BIOS of the external PC the function “Wake on LAN” must be activated.
It may be necessary to update the BIOS of older PCs for this function to be available.
•
The main power of the external PC must be active, but the PC can be in “Power save”
mode.
Enter hardware address
Enter the MAC address of the network card of the PC here.
Wake up remote host at
PowerOn
Yes
Starts the remote PC when the scanner is started.
No
:
Disabled the function.
Summary of Contents for Wide Tek WT 36C
Page 1: ...Setup Manual...
