8 Set-up Mode
In set-up mode, the user can set different parameters of the BOOKEYE Color.
8.1 Activating the Set-up Mode
The BOOKEYE Color must be off.
Press and hold the STOP button and then press the START button.
The lamps light up and the display shows in two lines:
Self Test
KBD vers.
(version number)
This message will be displayed until the end of the internal self-test sequence.
During the internal self-test sequence, all LEDs on the keyboard light up consecutively
.
After the self-test is completed, the LEDs light up in the same position which was active
when the device was switched off.
The display now shows the serial number of the BOOKEYE Color in two lines.
8.2 Checking the current settings
To check the current settings of the IP address, the subnet mask, the gateway address
and DHCP value, perform the following steps.
Press the up / down buttons at the FORMAT keyboard field to select the displayed value.
The display shows …
Serial number of the device
(e.g. BE2-SCL-N2)
Serial number of the device
IP:
AAA.BBB.CCC.DDD
Subnet:
AAA.BBB.CCC.DDD
Gateway
:
AAA.BBB.CCC.DDD
DHCP
YES / NO (displayed value depends on the current setting)
Operation Manual
Page 29
