OMH-6722B
5
C H A P T E R
2
O
PERATION
This chapter describes how to install and operate the OMH-6722B Silicon
Power/WaveHead in conjunction with a OMM-6810B Optical Multimeter. It is
divided into sections covering installation, power-up, front panel and rear panel
controls, and general operation. A detailed familiarization of the main unit
features are presented in Chapter 2 of the OMM-6810B Instruction Manual.
Installation
The OMH-6722B must be connected to the 6810B. Make sure the power to the
main unit is turned off and connect the cable from the 6722B to the
INPUT
connector on the rear panel of the 6810B.
Do not attach or remove the Optical Measurement Head while power is applied to
the
OMM-6810B. Please turn the power switch off when changing heads.
To avoid electrical shock hazard, connect the meter to a properly earth grounded,
three
prong receptacle only. Failure to observe this precaution can result in severe
injury or death.
StockCheck.com
Downloaded from StockCheck.com
Summary of Contents for OMH-6722B
Page 2: ...StockC heck com Downloaded from StockCheck com ...
Page 6: ...TA B L E O F C O N T E N T S iv OMH 6722B StockC heck com Downloaded from StockCheck com ...
Page 8: ...L I S T O F FIG U R E S vi OMH 6722B StockC heck com Downloaded from StockCheck com ...
Page 10: ...L I S T O F TA B L E S viii OMH 6722B StockC heck com Downloaded from StockCheck com ...
