Operation
The time axis (time range) and pressure axis (pressure 0..n) can be scaled, and the sam-
pling rate (saving interval) can be set with the dialog box elements below the diagram.
Only those buttons relevant to the currently set mode are active. Break (F7) and Reset (F9)
are not needed for the vacuum controller modes.
•
The buttons can be operated with the mouse, as on the controller
(see chapter 6.1).
•
The
UP
and
DOWN
arrow buttons change the temporary set value in active
MODE
.
•
The OK button sets the current pressure as the new set value in active
MODE
.
•
The
START
button starts the selected operating mode.
•
The
STOP
button ends an active operating mode.
The following menu items can be selected from the menu bar:
•
File
•
Measure !
•
Settings !
•
Alarm !
•
Calibrate !
•
Factory settings !
6.4.1 Menu
item:
„File“
File
Save settings
- Saving the Settings dialog settings in a file
Load settings
- Loading the Settings dialog settings from a file
Print settings
- Printing out an image of the Settings dialog on the standard printer
Save memory
- Saving the pressure data in a file
Print curve
- Printing out the current pressure curve on the standard printer
Password
- Changing the basic setting of the controller is password-protected.
Release is given by inputting the date as a hex number.
Example : 13.02.2005 = 130205 = 1FC9D
(Required for activating the "Calibrate" and "Factory settings" menus and the direct input of
pressure offset und pressure factor in the „Calibrate“ Dialog)
Info
- Information about the program version
Exit <ESC>
- Exit program
113184
25
