Starter Guide
L V R X - M I C R O S H A D E C O N T R O L L E R ( E 3 R - M B C F P - 0 2 )
EnOcean-compatible Wireless Lighting Control
AHD0152A
© 2008 Ad Hoc Electronics
Q U E S T I O N S ?
www.ILLUMRA.com (801) 225-2226
I N S T A L L A T I O N
CAUTION:
To be installed and/or used in compliance with
relevant electrical codes and regulations. If you are unsure
about any portion of these instructions, please contact a
qualified electrician.
CAUTION:
Intended for indoor use only, for permanently
installed fixtures only, and for dry locations only.
CAUTION
: Exceeding the voltage or current ratings of the Shade
Controller will void the warranty and may damage the unit. Do
not connect to any terminal with a voltage higher than VCC or
lower than GND. Do not exceed the current rating of 100 mA
(maximum) per output.
Note:
For optimal radio performance do not mount or place
receivers close to the floor or inside a metal housing.
High Voltage Installation [See Step 1.]
A. Connect the Power Pack relay to the power terminals of
the Shade Controller using the thin wires protruding from
the side of the Power Pack. Observe polarity; the ‘+’
terminal is the first one on the connector block (connect
the red wire to the VCC/+ terminal), followed by Ground
(connect the black wire to the GND/- terminal).
B. Connect the relay coil (blue wire on Power Pack) to UP1 of
the Shade Controller.
(Other Power Packs may be connected to DOWN1, UP2 and
DOWN2 by following the same procedure. Connect all the
thin black wires together and to the GND terminal of the
Shade Controller. In these instances, the thin red wires of
each additional Power Pack can just be left unconnected
since the Shade Controller already has power. Cap off these
wires – DO NOT connect them together.)
C. Connect one thick red wire from the top of the Power Pack
to the electrical load.
D. Connect the other thick red wire and the thick black wire
from the top of the Power Pack to the hot line voltage.
E.
Connect the thick white wire from the top of the Power
Pack and the neutral wire from the electrical load to the
neutral line voltage.
Low Voltage Installation [See figure 1.]
A. Connect power (+) to the VCC slot.
B.
Connect ground (-) to the GND slot.
C. Connect electrical load to the UP1 slot.
(Other loads may be connected to DOWN1, UP2 and
DOWN2 repeating Step C)
Figure 1.
LVRX-Micro Shade Controller (4-output)
Program Mode [See Steps 2-4]
A.
Enter the receiver into Program Mode by
pressing and
holding the LRN button for ~0.5 seconds. The load on UP1
will begin toggling.
B.
Press the button on the transmitter (See Step 3). The load
will stay ON for 4 seconds indicating that the receiver has
stored the transmitter in its memory.
C.
(If only one transmitter is desired on UP1 then skip Step C).
To program a second transmitter to UP1, wait until
toggling of the receiver resumes. Repeat the instructions in
UP1 – UP2 = Outputs
DOWN1 – DOWN2 = Outputs
GND = Power Supply (-)
VCC = Power Supply (+)
LRN = Program button
CLR = Clear button
