Introduction
The DALI-I-U DALI Input Unit has 4 inputs
which can be individually configured as digital
inputs for a DALI control system.
Press and Release actions can be defined
individually for each of the inputs through
software. This enables third party control
plates, sensors, door contacts etc. to be added
to the iLight DALI control network.
Dimensions
Installation
The unit should be installed in a dry
location, where ambient temperature
and humidity are within the operating
limits of the unit.
Warning
This device is classified as ELV.
Third Party devices used as input
devices for DALI Input Unit must have
mains rating (DALI bus provides basic
insulation only). Exposed conductive
parts must be earthed in accordance
with local wiring regulations.
DALI-I-U DALI Input Unit
Installation guide
41mm
*Do not extend cables
20mm
4mm Deep
Cable length
158mm*
Control wiring
DALI-I-U
includes 2 x polarity-free wires used to
connect to the DALI line (
0.5 mm²)
.
Cable colours
Purple: Input 1
Blue:
Input 2
Green: Input 3
Yellow: Input 4
Orange: COM
Red:
DALI bus
Brown: DALI bus
