12
/
13
3.2
Configuration illustration
Here is an example to illustrate how to setup speed dome, change the PTZ protocol of speed dome 002 to PELCO-D, then change the baud rate to 2400.
1.
In the mode of standby (icon a), press and hold on the “Setup” key for 3 seconds, login the main menu (icon b).
2.
Input the password (icon c, default password: 8888).
3.
Press [Enter] into setup menu, move the joystick up / down to choose [PTZ SETUP] / [SYS SETUP] (icon d).
4.
Choose [PTZ SETUP] and press [Enter] into [PTZ SETUP].
5.
Move the Joystick left and right to select the address (ID) of speed dome, e.g. 002 (icon e, f), then press [Enter] into next level menu (icon g).
6.
Move the joystick up / down to select PTZ protocol, e.g. PELCO-D (icon h).
7.
Move the joystick right to change the baud rate (icon i), and then select the correct baud rate (icon j).
8.
Press [Enter], then press “ESC” back to the standby mode (icon a).
9.
Configuration is done
Summary of Contents for IKB-2888
Page 6: ...6 13 2 2 Typical Wiring Diagram ...
Page 7: ...7 13 ...
