Doc ID: TN-052 HMT-402 & Series Basic Setup V1.doc
Page: 1 of 2
Prepared by: DN
Date: 17-Dec-2013
Approved by: TN
Date: 17-Dec-13
IKUSI ANZ TECHNOTE
TN-052: HMT-402 & S
ERIES BASIC SETUP SHEET
Introduction
The HMT-402 is a stand-alone four HDMI inputs (HMT-201 & HMT-101 are dual and
single HDMI respectively) to DVB-T modulator. There are many settings in the DVB-T
modulators where conflicts can occur, so it is advisable to take some time to
familiarize yourself with the equipment, especially before attempting to install one.
Always refer to the operation manual where appropriate.
If you are using more than one HMT in a cable network, you will need to set
them up in a workshop beforehand, and make sure you have a laptop and LAN cable when installing.
This is a DIGITAL device. Firmware updates are available from link below, however if unsure please contact
Ikusi.
https://sites.google.com/site/ikusitechnotes/
Overview
The HMT-4xx has a front-panel control and a web-based interface (NMS). For access to the full range of settings,
you will need to access the web interface of the HMT-4xx with Mozilla Firefox browser and a LAN cable for direct
connection. In this case, set a different IP address on each HMT, so you can access them easily.
Basic Setup
Where a setting is accessible only through the web interface, it will be denoted as (web). Otherwise, the setting is
able to be changed on the front panel, and will be denoted as (LCD). All settings on the front panel are able to be
configured through the web interface as well.
Remember, more than one HMT in a cable network requires access to the web interface.
System Settings (Web)
Set your computer or laptop LAN adaptor for 192.168.0.100
Set the subnet mask 255.255.255.0
If you are unsure how to do this, technote 42 can be used as a guide although it has been written for XP
computer and may be slightly different for windows 7 and upwards.
Use Mozilla or chrome browser and type in IP address 192.168.0.136
This will open a web interface with login admin password admin
Password can be changed, however you need to make sure you file information in a secure place
for future reference and access
Input 1 & Input 2 Stream/Services Settings
Setup input settings for HDMI inputs 1 to 4 selecting MPEG2 or H264 input dependant
Set video bit rate no higher than 10Mbps.
Audio format & Audio Bitrate only need to change if you have special requirement
Program name can be change to your specific requirement (Current HMDI-111. HDMI-112, HDMI-211,
HDMI-212)
Refer to manual re Service ID, FMT PID, Video PID, Audio PID, PCR PID, settings do not change unless
you fully understand their function.,
Program out enable A /B means that program will appear on A or B RF output, in the case of HMT-402
AUSTRALIAN HEAD
OFFICE
7 Amsted Road
Bayswater 3153
Ph: (03) 9720 8000
Fax: (03) 9720 7422
